ANY-maze Help > I/O devices supported by ANY-maze > I/O errors that may occur during a test > Syringe Pump error

Syringe Pump error

Introduction

When you use a syringe pump in ANY-maze, you will set up its target volume and flow rate, and then start or stop the pump running (either from within a procedure, or because the pump starts running when the test is started).

If at any point the syringe does not contain enough liquid to dispense, it may stall - that's when ANY-maze is still trying to run the pump, but it's reached the end of its travel. When this happens, a warning will be generated.

Details

The following specific error conditions can be reported:

Syringe pump stalled

The syringe puymp has stalled, as described above.

For further information about this error, please contact ANY-maze Support.

ANY-maze help topic T1315