ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Inputs and outputs > Laser controllers > Setting up a laser controller

Setting up a laser controller

Introduction

For a general introduction to laser controllers, see An introduction to laser controllers.

To add a laser controller to a protocol, click the Add item button in the ribbon bar and select New output item > New laser controller from the menu which appears.

The New output item menu option is only included if the protocol mode includes input/output.
The New laser controller option will be disabled until the protocol includes at least one apparatus element.

What you need to do

Each of the steps below is a link, which you can click for more information.

 1.Enter the laser controller's name 
 2.Specify the effect of activating the laser controller 
 3.Optionally, specify the laser controller's intensity 
 4.Set the laser controller's activation and reset options 
 5.Specify whether the physical port used by the controller is always the same, or whether it depends on the location of a movable zone 
 6.Specify the physical port (or ports) used by the controller  

See also:

 •Adding elements to a protocol 
 •Editing a laser controller 
 •Deleting a laser controller 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0241