ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Analysis > Analysis options > Options for analysis of heading errors

Options for analysis of heading errors

Introduction

ANY-maze includes a number of measures that relate to the animal's Heading error (sometimes also called 'angular deviation'). These measures indicate how far the animal deviated from a direct course to a zone or a point.

Specifically, ANY-maze can calculate the Initial heading error to a zone or point and also the Average heading error. The options described here are used to define exactly how these calculations are performed.

 •Specifying how to determine the animal's initial heading 
 •Specifying how to analyse headings to zones  

Specifying how to determine the animal's initial heading

To calculate an initial heading error, it's clearly necessary to define what the animal's initial heading actually is.

ANY-maze provides two methods for doing this. You can either specify that the initial heading is the vector from the animal's first position in the test to its position after a short delay has elapsed, or that it's the vector from the animal's first position in the test to the first position outside a circle of a certain radius centred on the first position in the test.

When using a delay, you should specify the duration you wish to use either in seconds or in milliseconds by using the units s and ms respectively. You can enter any value from 1ms to 10s.

When using a distance, you should specify the radius of the circle including units of m (metres), cm centimetres or mm millimetres. You specify any distance from 1mm to 10m.

Specifying how to analyse headings to zones

ANY-maze provides two methods to specify a heading to a zone - either the heading to the centre of the zone, or the heading to any point on the zone perimeter.

In fact, using the second of these options is the most correct method, but it is computationally intensive and may cause results analysis to slow down significantly. In this case, you may wish to use the heading to the zone's centre as an approximation of the heading to the zone (particularly for small zones where the difference is negligible).

Clearly, if you do use the centre of the zone to determine the heading to the zone, then ANY-maze will have to identify where the centre actually is. It does this using the zone's centre of mass (i.e. the mean x, y coordinate of all the points within the zone), but it's important to understand that this point may not actually be within the zone. For example, consider a ring shaped zone - the centre of the zone will be at the centre of the ring, but this point won't lie within the zone.

See also:

 •Zone measures 
 •Point measures 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0653