ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Inputs and outputs > Signals > Setting up a signal

Setting up a signal

Introduction

For a general introduction to signals, see An introduction to signals.

To add a signal to a protocol, click the Add item button in the ribbon bar and select New input item > New signal input from the menu which appears.

The New input item menu option is only included if the protocol mode includes input/output.
The New signal input menu option will be disabled until the protocol includes at least one apparatus element.

What you need to do

Each of the steps below is a link, which you can click for more information.

 1.Enter the signal's name. 
 2.Optionally enter conversion parameters to convert the signal from volts to real-world units. 
 3.Optionally set up details of the signal's baseline. 
 4.Specify whether the physical port used by the signal is always the same, or whether it depends on the location of a movable zone. 
 5.Specify the physical port (or ports) used by the signal.  

See also:

 •Adding elements to a protocol 
 •Editing a signal or filtered signal 
 •Deleting a signal or filtered signal 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0157