ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Analysis > Analysis across time > Setting up a Time period

Setting up a Time period

Introduction

For a general introduction to time periods, see An introduction to Time periods.

To add a time period to a protocol, click the Add item button in the ribbon bar and select New time period from the menu which appears.

What you need to do

Each of the steps below is a link, which you can click for more information.

 1.Enter the time period's name 
 2.For a 'fixed' period, specify the start and end of the period 
 3.For a period that differs between stages, specify the start and end time in each stage 
 4.For a period that depends on a time marker defined by a procedure, specify the how long before (or after) the time marker the period should start and end 
 5.For a period that is based on the results of calculations, specify which calculations determine the start and end of the period 
 If your protocol was created in a version of ANY-maze prior to V5.1, and uses Events and actions rather than procedures, you can specify that the time period is based on an event rather than a time marker.  

See also:

 •An introduction to Time periods 
 •Editing a Time period 
 •Deleting a Time period 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0643