ANY-maze Help > I/O devices supported by ANY-maze > Ugo Basile instruments supported by ANY-maze > The Ugo Basile Thermal Gradient Ring > Thermal Gradient Ring configuration

Thermal Gradient Ring configuration

Introduction

The Thermal Gradient Ring configuration window is used to show information about your Thermal Gradient Ring, and allows you to change its ID and update its firmware.

Accessing the Thermal Gradient Ring configuration window

To access the Thermal Gradient Ring configuration window, select your Thermal Gradient Ring in the list on the left side of the I/O page and then click the Configure this device button in the ribbon bar.

Figure 1. The Thermal Gradient Ring configuration window.

Changing the device ID

The method of changing the device ID is the same as for all ANY-maze interface devices, on which the Thermal Gradient Ring is based. Full details, including what the device ID is and why you might want to change it, can be found here.

Updating the device firmware

The process of updating the firmware is the same for all ANY-maze interface devices, on which the Thermal Gradient Ring is based. Full details can be found here.

See also:

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T1265