ANY-maze Help > I/O devices supported by ANY-maze > The ANY-maze interface device family > The ANY-maze Analogue interface > Setting up the ANY-maze Analogue interface

Setting up the ANY-maze Analogue interface

You MUST install the 'ANY-maze USB devices' driver software before you plug the ANY-maze Analogue interface into your computer.

  

All ANY-maze interface devices are set up in the same way, therefore the links below will take you to some generic instructions:

 1.Install the 'ANY-maze USB devices' driver software 
 2.Connect the ANY-maze Analogue interface to your computer 
 3.If you have more than one ANY-maze Analogue interface, you should identify which one is which 
 4.If you wish, you can rename the device to give it a more meaningful name  

What next?

After setting up your device, you may wish to configure it, after which you will need to connect it to your equipment and test it.

See also:

 •Using the ANY-maze Analogue interface in tests 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T1082