ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Inputs and outputs > Signals > Setting up a filtered signal

Setting up a filtered signal

Introduction

A signal can be used as the source of any number of filtered signals. For example, a signal from an EEG device could have different filtered signals derived from it for the different EEG waves - Delta, Theta, Alpha, etc.

It's important to understand that you must first include the unfiltered 'source' signal in your protocol, and then add a filtered signal to it.

Adding a filtered signal

To add a filtered signal, first select the 'source' signal in the protocol list, then click the Add item button in the ribbon bar and select New input item > New filtered signal from the menu which appears.

You can add any number of filtered signals to a single 'source' filter.

What you need to do

Each of the steps below is a link, which you can click for more information.

Enter the filtered signal's name.

Specify the filtered signal's filter characteristics.

Choose whether or not to integrate the filtered signal.

Optionally, set up details of the filtered signal's baseline - this is exactly the same as setting up an unfiltered signal's baseline.

Setting up a filtered signal

Introduction

Adding a filtered signal

What you need to do

See also: