ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Inputs and outputs > Selectors > Setting up a selector

Setting up a selector

Introduction

For a general introduction to selectors, see An introduction to selectors.

To add a selector to a protocol, click the Add item button in the ribbon bar and select New output item > New selector from the menu which appears.

The New selector menu option is only included if the protocol mode allows this type of port to be added. Currently, the only protocol mode which supports this is Operant mode.
The New selector option will be disabled until the protocol includes at least one apparatus element.

What you need to do

Each of the steps below is a link, which you can click for more information.

 1.Enter the selector's name 
 2.Enter names for the possible values of the selector 
 3.Specify whether the physical port used by the selector is always the same, or whether it depends on the location of a movable zone 
 4.Specify the physical port used by the selector  

After completing these steps, you should review the First stage that ANY-maze has automatically included in this protocol and also enter the duration of the tests in the stage. Then you should consider whether you want to add any further stages.

See also:

 •Adding elements to a protocol 
 •Editing a selector 
 •Deleting a selector 
 •The ANY-maze Operant interface 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0303