ANY-maze Help > I/O devices supported by ANY-maze > The ANY-maze interface device family > The ANY-maze Optogenetics interface > Setting up the ANY-maze Optogenetics interface
Setting up the ANY-maze Optogenetics interface
 | You MUST install the 'ANY-maze USB devices' driver software before you plug the Optogenetic interface into your computer. |
All ANY-maze interface devices are set up in the same way, therefore the links below will take you to some generic instructions:
| 1. | Install the 'ANY-maze USB devices' driver software |
| 2. | Connect the ANY-maze Optogenetics interface to your computer |
| 3. | If you have more than one ANY-maze Optogenetics interface, you should identify which one is which |
| 4. | If you wish, you can rename the device to give it a more meaningful name |
What next?
After setting up your device, you may wish to configure it, after which you will need to connect it to a laser and test it.
See also:
| • | Using the ANY-maze Optogenetics interface in tests |
© Copyright 2003-2026 Stoelting Co. All rights reserved
ANY-maze help topic T1048