ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Reports > Results reports > Setting up a results report > Setting up a track plot section

Setting up a track plot section

Introduction

For a general introduction to report sections, see Adding sections to a report.

Track plot sections show track plots for groups of tests in an experiment. This can act as a good, although subjective, way to visualise an experiment's results.

To add a track plot section to a results report, click the Add item button in the ribbon bar and select New report section from the menu which appears. On the sub-menu which is then shown, select New track plot section.

What you need to do

Select the Track plot you want to show

Use the Track plot drop-down list to specify the Track plot you want the section to show. The list will include all the track plots that are part of your protocol; if there are none listed then you will need to add a track plot to the protocol before you can finish setting up the section.

Select the way you want the track plots to be grouped

Simply use the three drop-down lists to select how the track plots should be grouped in the report. For example, selecting Trial and Treatment would cause all the track plots for the first trial to be shown grouped by treatment. Then all the track plots for the second trial would be shown, also grouped by treatment; then the third trial, etc.

You must select at least one grouping measure.

Setting up a track plot section

Introduction

What you need to do

See also: