ANY-maze Help > I/O devices supported by ANY-maze > The ANY-maze interface device family > The ANY-maze Optogenetics interface > The ANY-maze Optogenetics interface output ports

The ANY-maze Optogenetics interface output ports

Introduction

The ANY-maze Optogenetics interface has four output ports, each of which can be configured either as a laser controller output or as a TTL output.

Connecting to the ports

The output ports use BNC connectors with a pin-out of:

By default the outputs are active high, but this can be changed in the configuration window.

Using the ports

To use a port that's configured as a laser controller, you will need to include a laser controller in your protocol. This is described in detail here. To use a port that's configured as a TTL output, you will need to include an On/off output in your protocol. In either case, you may also want to include a procedure to actually control when in the test the laser or TTL output turns on.

Optogenetic interface port specification:

Laser controller port:

TTL output port:

See also:

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T1052