ANY-maze Help > The ANY-maze reference > The Protocol page > The elements of a protocol > Reports > Results reports > Setting up a results report > Setting up a statistics section > Select the independent variables you want to use

Select the independent variables you want to use

In brief

You should use the two drop-down lists shown on the statistics section's settings page to select one or two independent variables that you want to use in the analysis. Only measures which can logically be used as independent variables are listed.

See also:

 •Information measures 
 •Apparatus measures 
 •Zone measures 
 •Point measures 
 •Sequence measures 
 •Key measures 
 •On/off input measures 
 •Rotary encoder measures 
 •Signal measures 
 •Sensor measures 
 •Movement detector measures 
 •On/off output measures 
 •Speaker measures 
 •Shocker measures 
 •Pellet dispenser measures 
 •Laser controller measures 
 •Syringe pump measures 
 •OPAD measures 
 •Light controller measures 
 •Procedure measures 
 •Event measures 
 •Virtual switch measures 

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0717