ANY-maze Help > The ANY-maze reference > The Support page > Drivers > ANY-maze USB device driver

ANY-maze USB device driver

Only Windows administrators can install and uninstall drivers. You'll also need to be an ANY-maze administrator, unless your administrator has specified in the Administrative options that all users, not just administrators, can do this.

Introduction

The ANY-maze USB device driver is contained within the ANY-maze software, and is usually pre-installed by default when you install the ANY-maze system itself. You can use the Drivers option on the Support page to confirm whether the driver is installed, and to install and uninstall it as required.

The USB device driver is used for the following I/O devices:

 •The ANY-maze interface device family 
 •The ANY-maze interface (AMi) 
 •The ANY-maze remote start switch 
 •The ANY-maze TTL cable 
 •The ANY-maze shocker cable 
 •The Activity wheel 
 •The Parallel Rod interface 
 •The Orofacial Pain Assessment Device (OPAD) cage 
 •The Waterwheel Forced Swim Test Tank  
You should ensure this driver is installed BEFORE attaching any of the devices listed above to your computer.

How to install or reinstall the ANY-maze USB device driver

To install this driver, you should do the following:

 1.Select the Support page. 
 2.Select the Drivers option in the left-hand side-bar. 
 3.Look at the entry for ANY-maze USB devices - the status should read 'Installed'. 

Click here to open the Drivers settings now.

If the driver isn't installed, then you should simply select it in the drivers list and click the Install driver button in the ribbon bar.

How to uninstall the ANY-maze USB device driver

To uninstall this driver, you should do the following:

 1.Select the Support page. 
 2.Select the Drivers option in the left-hand side-bar. 
 3.Look at the entry for ANY-maze USB devices. If the status reads 'Installed' then click the entry in the list (to select it) and then click the Uninstall driver button in the ribbon bar.  

Note that if you uninstall the entire ANY-maze software, then this driver will, if necessary, be uninstalled automatically.

Installing an ANY-maze USB device

Once the ANY-maze USB device driver has been installed on your computer, installing one of the USB devices listed above, such as an ANY-maze interface device (AMi), is as simple as plugging it into a USB port. This will cause the Windows Found new hardware wizard to run, where you can just select the default options on every page.

If, during device installation, you see a warning telling you that the device driver has not passed Windows logo testing, you should select the Continue anyway option, otherwise your device won't be installed.

© Copyright 2003-2026 Stoelting Co. All rights reserved

ANY-maze help topic T0975